Water Tube Boiler Sketch Graph

Contact Us

Product thermal capacity: 0.7 - 14 MW

Working pressure: 0.7 - 1.25 Mpa

Available fuel: Nature gas, coke oven gas, biogas, methanol, liquid propane gas, diesel, heavy oil, light oil, crude oil, etc.

Available industries: Heat supplying, hospital, hotel.

Introduction

WNS series horizontal internal combustion boiler is classic 3-pass wetback oil/gas fired boiler. After fuel is atomized by burner, flame is full of the wave furnace and transfer heat via furnace wall, called 1st pass; the high temperature flue gasses are collected in reversal chamber and then enter 2nd pass, which is grooved tube bundle area through heat convection, air temperature gradually falls and flows to front smoke box and enter 3rd pass, which is done in the smooth tube bundle area, and then through back smoke box lead to chimney and exhausted to the atmosphere.

Technical Advantages

Digitized Manufacture

The key processes including material cutting, rolling, drilling are made by advanced CNC machining process to reduce the assembly stress and extend boiler working lifetime.
The front and back smoke chamber plates are cut by CNC plasma cutting machine with tidy and beautiful look.

Easy Operation and Maintenance

Fully intelligent operation, with automatic adjustment and protection of burning, water level, temperature and steam pressure. The smoke box door uses the hinge structure for easy inspection, inventory and cleaning.

Long Service Life

The way to weld Smoke tube and tube sheet is to first expand to eliminate the gap between them, then adopt automatic argon arc welding to relief the stress and expand boiler service life.
Longitudinal and girth joint adopt advanced automatic submerged-arc welding for good welding quality. All longitudinal and girth joint are test by radiographic inspection.
Fin tube uses ND steel or stainless-steel material to avoid corrosion in the low temperature.
Inspection stops are set up to guarantee the sequence of expanding and welding to avoid cracking of the tube sheet holes.

Less Fuel Consumption

High quality aluminum silicate fiber is used with fire clay insulation, to control the boiler body temperature below 45℃ and reduce heat lost.
Sufficient steam storage room and heating area to generate high quality steam and high thermal power.
Condenser is added to recycle the waste heat of the exhausted smoke to increase feeding water’s temperature and reduce flue gas emission temperature and increase the thermal efficiency over 98% and save operating cost.

Rankine Cycler Lab Experiment Manual - Turbin

2016-9-3 · Locate the water level in the boiler if it is filled with 5,500 ml of water. (Sketch location) Will there be space unoccupied by water? If so, how much volume? Will any of the flame tubes not be covered by water? Number? If so, what is the significance of this? Barometric Pressure What is the present barometric pressure in your area?

Domestic water-supply - examp

2018-12-5 · In this section I show how to calculate the flow-rate in a real domestic water-supply system by using a couple of design tools that link flow-rate to the available head - the pressure that makes the water move. The worked example starts here .If all you need is the graph that links flow rate to the rate-of-pressure-drop for standard pipe sizes, it's here .

Domestic Hot Water Loads, System Sizing and Selectio

2015-3-2 · Domestic Hot Water Loads, System Sizing and Selection for Multifamily Buildings outdoor air, boiler water (aquastat) and DHW; and burner on-off times. Eight upgraded buildings had additional data end graph illustrates that the weekend peak is greater, at 1.09 gal/capita, than any of the weekday peaks, at 0.87

American Society of Power Engineers, In

The American Society of Power Engineers, Inc. (ASOPE™) is an independent third party licensing agency whose objective is to establish national standards and a formal structured level of competence for national and international recognition of the power engineer.

(PDF) Marcet Boiler | Wan Abdul Hamid - Academia.e

The unit of Marcet Boiler was later connected to the nearest power supply. Valve at the feed port and the level sight tube were opened. After that, the boiler was filled with distilled water through the feed port and the water level was made sure to be at about half of the boiler's height.

B.E. EEE MARINE, Semester - V. Marine Engineering UNI

2018-1-27 · 15. What is boiler feed water treatment? 16. What is air ejectors? 17. What is boiler water tests? 18. What is boiler mounting? 19. Name the types of flame in boiler? 20. What is turndown ratio? Part – B 1. Draw a Cochran Boiler? 2. Sketch a Water tube boiler? 3. Explain about boiler gauge glass blow through procedure? 4. What is blow down

Triangle Tube 100 w/o primary/secondary??

We irrigate 2500 acres of hay through center pivot irrigation systems. Pumping water is my livelihood. Using electricity to do it is also a necessity. The Grundfos handbook and TT literature show that the entire system falls within the 15-58 curves. I'm not sure the Triangle Tube will be the boiler I go with, may look into Peerless Purefire as

Triangle Tube 100 w/o primary/secondary??

We irrigate 2500 acres of hay through center pivot irrigation systems. Pumping water is my livelihood. Using electricity to do it is also a necessity. The Grundfos handbook and TT literature show that the entire system falls within the 15-58 curves. I'm not sure the Triangle Tube will be the boiler I go with, may look into Peerless Purefire as

Boiler Types and Classifications - Wiki - odesie b

A hot water boiler, strictly speaking, is not a boiler. It is a fuel-fired hot water heater. Because of its similarities in many ways to a steam boiler, the term ''hot water boiler'' is used. Hotwater boilers that have temperatures above 250° Fahrenheit or pressures higher than 160 psig are called ''high temperature hot water

TIME SCHEDULE MODULE TOPICS PERIODS 17 2 17

2011-11-12 · TIME SCHEDULE MODULE TOPICS PERIODS 1 Introduction Steam Generators Properties of Steam Thermodynamic Vapour Cycle 17 1.2.6 Compare fire tube boilers and water tube boiler 1.2.7 State the functions and working of boiler mountings such as stop valve, safety valve, 1.3.2 Explain the formation of steam at constant pressure with a graph

HEAT EXCHANGERS - University of Babyl

2011-4-26 · Shell-and-tube heat exchangers are further classified according to the number of shell and tube outer tube (the shell) is 3 cm. Water flows through the tube at a rate of 0.5 kg/s, and the oil through the shell at a rate of 0.8 kg/s. Taking the average temperatures of the condenser or a boiler undergoes a phase-change process, and